Home Remodeling Contractor

Kitchens, baths, and whole-house remodels built code-correct

Home Remodeling Contractor Irvine CA

As a Home Remodeling Contractor Irvine CA homeowners call first, we handle the drawings, permits, and trades that turn a dated kitchen or cramped bath into a room you actually use. PeakStruct Group runs remodels across Orange County with a CSLB General B License and crews who show up when they say they will. Whether you need a home remodeler Irvine California for a single bathroom or a full-house renovation, we walk the job, price it honestly, and build it once, right.

Live phone supportUpfront optionsBacked workmanship
Call firstLive triage can help before arrival
Safety before speedRisks assessed before work begins
Diagnose the causeWe trace the source, not just the symptom
Approve the workScope and price explained upfront

What's included

What Our Home Remodeling Service Includes

Every remodel is different, but most projects include the same core scope. Here's what's covered in a typical PeakStruct Group job, and what we price separately if you add it.

01

Permits and Inspections

We pull the required City of Irvine permits, prepare submittals, and meet the inspector at rough-in and final. Permit fees vary by scope and are itemized in your estimate so you see the cost.

02

Demolition and Haul-Off

We remove old cabinets, tile, drywall, and fixtures, protect floors and adjacent rooms with plastic barriers, and haul debris daily. Dumpster fees are included in the estimate.

03

Rough Trades

Framing, electrical, plumbing, and HVAC rough-in are handled by licensed trades and inspected before drywall goes up. We coordinate the sequence so the trades don't hold each other up.

04

Finishes

Drywall, paint, tile, grout, cabinetry, countertops, and fixtures are installed to the spec in your scope. We use brands like Kohler and Moen for fixtures and Sherwin-Williams for paint.

05

Final Walk and Warranty

We walk the finished job with you, fix punch-list items, and hand over warranty paperwork. You get care instructions for tile, grout, and countertops so the finishes hold up.

Service overview

Home Remodeling Contractor Irvine CA

A Home Remodeling Contractor Irvine CA is a licensed general contractor that plans, permits, and builds residential renovations, from a 60-square-foot bathroom gut to a 2,000-square-foot whole-house remodel. The work covers demolition, framing, drywall, electrical, plumbing, tile, cabinetry, countertops, and paint, all sequenced so the trades don't trip over each other. We pull the permits, schedule inspections, and keep the job moving through Irvine's plan-check process.

Irvine homes present specific conditions: 1980s and 1990s tract builds in Woodbridge and Westpark with original galvanized plumbing, newer Great Park and Portola Springs houses where the layout is fine but the finishes are builder-grade, and hillside properties in Turtle Rock and Shady Canyon with structural quirks. A home remodeler Irvine California who knows those patterns saves you weeks of guesswork. We've walked enough Irvine kitchens and baths to spot water damage behind a vanity or a foundation crack under a sliding door before demo starts.

One Licensed TeamWe hold a CSLB General B License and carry OSHA 30 training on every crew. That means framing, electrical, plumbing, and finish work are coordinated by one accountable contractor instead of five subs who blame each other. You get one schedule, one point of contact, and one warranty.
Permits HandledIrvine requires permits for structural, electrical, plumbing, and most kitchen and bath changes. We pull them, prepare the submittals, and meet the inspector on site. Skipping permits can void insurance and stall a future sale, so we don't cut that corner. Typical plan check runs two to four weeks depending on scope.
Fixed, Written PricingYou get a line-item estimate before demo, not a vague ballpark. If we open a wall and find dry rot or knob-and-tube wiring, we stop, show you photos, and price the fix before proceeding. No surprise change orders buried at the end. That's how an affordable Home Remodeling Contractor Irvine CA should operate.
Quality Home Remodeling Contractor in Irvine
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.

The service timeline

How Our Remodel Process Works

The process flexes to the condition, but these checkpoints keep decisions clear.

01

Walk-Through

We meet at your Irvine home, measure the space, and talk through what you want. You get honest feedback on what's feasible and what the budget likely supports. This visit takes 45 to 90 minutes, and there's no charge for the estimate.

Stage 1
02

Design and Estimate

We put together a scope, a line-item estimate, and a rough schedule. If you need drawings for permits, we coordinate with a designer or draftsperson. You review everything before signing, and we answer questions until the numbers make sense.

Stage 2
03

Permits and Pre-Construction

We submit plans to the City of Irvine, order materials, and schedule the trades. Lead times on cabinets and countertops run four to eight weeks, so we order early. You get a start date and a sequence of who's in your house when.

Stage 3
04

Build and Inspect

Demo starts, then framing, rough electrical and plumbing, insulation, drywall, tile, cabinets, and finish. Inspections happen at rough-in and final. We keep the site clean and walk you through progress at the end of each week.

Stage 4
05

Punch List and Handoff

We walk the finished job with you, note anything that needs adjustment, and fix it before final payment. You get warranty paperwork and care instructions for tile, grout, and countertops. We're reachable after the job if something needs attention.

Stage 5

Tools & methods

Tools and Methods We Use

Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.

01

Milwaukee and DeWalt cordless tools

Drills, impact drivers, reciprocating saws, and circular saws for demo and framing. Cordless keeps the job site clean and lets us work in tight spaces without running extension cords.

02

Bosch laser level

Sets cabinet lines, tile layout, and framing elevations. A laser level catches a wall that's out of plumb before the cabinets go up, which saves a callback.

03

Tile cutter and wet saw

Cuts porcelain, ceramic, and natural stone for floors, showers, and backsplashes. Clean cuts mean tight grout lines and fewer chipped edges.

04

Drywall lift

Holds full sheets in place while we fasten them to the ceiling and upper walls. It makes a two-person job safer and faster, especially on vaulted ceilings.

05

Nail gun and air compressor

Framing, trim, and cabinet installation. Consistent nail depth and speed matter when you're installing hundreds of linear feet of trim.

06

Concrete mixer

For small foundation repairs, shower pan mud beds, and patio work. Mixing on site gives us control over the mix ratio and cure time.

Use cases

When to Call a Home Remodeling Contractor

These examples show how the service framework adapts rather than forcing every call through one repair.

Home Remodeling Contractor
Woodbridge Kitchen Wall RemovalA 1988 Woodbridge kitchen with a wall separating it from the dining room, original oak cabinets, laminate counters, and a dropped ceiling that made the room feel small. → We removed the wall, installed a structural beam, raised the ceiling, and installed new cabinets, quartz countertops, and a tile backsplash. The project took six weeks and passed all inspections on the first try.

Northwood Bathroom Leak Repair

A Northwood bathroom with a leaking shower pan that had stained the ceiling below, cracked floor tile, and a vanity with water damage at the base. → We gutted the bathroom, replaced the shower pan and waterproofing membrane, installed new tile, a Kohler vanity, and Moen fixtures. The job took three and a half weeks and the flood test passed before tile.

Great Park Move-In Upgrade

A new Great Park house with builder-grade carpet, white walls, and a basic kitchen backsplash. The homeowners wanted it upgraded before moving in. → We installed luxury vinyl plank flooring, painted the interior with Sherwin-Williams paint, added a tile backsplash, and upgraded bathroom fixtures. The work finished in four weeks, before the move-in date.

Problems we solve

Remodeling Problems We Solve for Irvine Homeowners

Remodels rarely go exactly to plan. These are the issues we run into most often in Irvine homes and how we handle them before they become expensive.

ISSUE

Water damage behind walls

We open the wall during demo, inspect the framing, and treat or replace any damaged material. If mold is present, we follow EPA Lead-Safe protocols and remediate before closing the wall. The fix is priced before we proceed.

SYMPTOM

Permitting delays

We prepare submittals to Irvine's requirements and respond to plan-check comments quickly. We build permit time into the schedule so you're not surprised when the start date shifts.

SIGN

Budget overruns

We provide a line-item estimate and a written scope. If we find something unexpected, we stop and price it before proceeding. You approve every change order before the work continues.

ALERT

Subcontractor no-shows

We schedule our own crews and a vetted bench of trades we've worked with before. If a trade falls through, we have backups. You get a weekly update so you always know who's coming.

Pricing process

Home Remodeling Costs in Irvine

$18,000 - $200,000+ depending on scope

Phase 01

Scope and size

A powder room costs less than a primary bath, and a galley kitchen costs less than an open-plan kitchen. Square footage and the number of fixtures drive the base cost.

Phase 02

Layout changes

Moving plumbing or electrical adds cost because it means opening walls and rerouting lines. Keeping fixtures in place saves money on any remodel.

Phase 03

Material grade

Quartz countertops cost more than laminate, and porcelain tile costs more than ceramic. We help you pick materials that fit the budget without looking cheap.

Questions before we arrive

Frequently Asked Questions

Home Remodeling Contractor
Call (949) 236-6306
How much does a Home Remodeling Contractor cost in Irvine CA?

Most Irvine bathroom remodels run $18,000 to $45,000, and kitchens run $35,000 to $95,000 depending on size and finishes. Whole-house remodels can exceed $200,000. Labor typically accounts for 40 to 50 percent of the total. We provide a free estimate with line-item pricing so you can see where the money goes before you commit.

What does a Home Remodeling Contractor do in Irvine California?

A Home Remodeling Contractor in Irvine CA handles design coordination, permits, demolition, framing, electrical, plumbing, drywall, tile, cabinetry, countertops, and paint. We manage the schedule and the trades so you don't have to hire five separate subs. We also handle inspections and the final punch list. In short, we take a room from dated to done.

Who is the best Home Remodeling Contractor in Irvine CA?

The best Home Remodeling Contractor in Irvine California is one who is licensed, insured, and can show you recent local jobs. Ask for the CSLB license number, proof of insurance, and references from Irvine homeowners. We're happy to provide all three. We also give you a written scope and schedule so you can compare bids apples to apples.

Do I need a Home Remodeling Contractor for my Irvine house?

If your project involves structural changes, electrical, plumbing, or permits, yes. Irvine requires permits for most kitchen and bath remodels, and unpermitted work can complicate a future sale. A licensed Home Remodeling Contractor Irvine CA pulls the permits and builds to code. For cosmetic work like paint or flooring, you may not need one, but we're glad to advise.

Ready when you are

Get Your Home Remodeling Contractor Irvine CA Estimate

Call (949) 236-6306 and we'll schedule a free walk-through at your Irvine home. You get a written, line-item estimate and an honest schedule, with no pressure and no surprise fees. Licensed, insured, and ready to start.

Home Remodeling Contractor

Talk with the local team

Request Home Remodeling Contractor

Call (949) 236-6306 or email info@peakstructgroup.com to schedule your free estimate. We answer the phone Monday through Friday from 8:00 AM to 6:00 PM, and we return after-hours messages first thing the next morning. For emergencies, call any time and we will get back to you as soon as possible.

3750 Barranca Parkway, Irvine, CA 92606, United States, Irvine, CaliforniaMain office · technicians serve the full area

Thanks — your request is in. We will contact you shortly.

Call now